Just used the Leatherman I had on me to get the clamp off, was tough to get back on, but didnt take more than a couple minutes. Although it was tougher to prop the washer up and get the bottom square drive screws off for the panel than it was the spring clamp. a maternity bra pad, was stick in the drain pump. Didn't complete the wash, had water in the bottom and it clicked when I tried to drain. washer stopped working last night (Kenmore actually a Frigidaire 417). This old post helped me out and saved me some $$$.Īmazing.
#FRIGIDAIRE FWT647GHSO MANUAL MANUAL#
It would not drain and made some clicking noises.ġ - I drained most of the standing water from inside the washer.Ģ - I took the bottom panel off by reading my manual and finding the location of two screws located near the bottom.ģ - I removed the big rubber hose/trap by pinching the clamp and pulling it off.Ĥ - Cleared out the maternity bra pad that was blocking the passage to the tiny white plastic pump.ħ - Registered at to post this. This old thread helped me to get my front loading Frigidaire washer up and running again. and go to an auto parts store and buy a few automotive hose clamps. Grab a camera and take a few pix before you disconnect anything. I put everything back together and now the washer is working fine! There is a second screw (on the right of the pump), but the pump has a slot that allows you to slide the pump back into it and rotate the pump back into position. You can then swivel the pump towards you and remove it. To remove the pump, just remove the screw on the left of the pump (if machine is viewed from behind). If I remember correctly, the error message was E21. It was blocking the exhaust flow of the discharge water. My washer had a detergent/fabric softener 'napkin' jammed inside of that big black rubber hose. There's a plastic filter inside of that big 's located in the 'accordion' part of that hose. You have to remove all of those spring clamps and you have to remove that big black hose. There are 3 small green spring clamps, and one larger silver wire screw clamp. The remaining 2 connections/openings (one large, one small) connect to the upper interior of the machine. One goes to the pump (located on the floor of the machine) The hose I'm referring to has 3 connections/openings: Ths will make it much, much easier to access the pump, hoses, etc. If possible, place the washer on its side. You have to remove the back panel to access that hose. Be sure to really inspect the big black rubber hose located inside the machine.
0 kommentar(er)
